| SW1 | Dip | DIP settings | Function | |||
|---|---|---|---|---|---|---|
 | 1 | OFF | Baud-rate 57600 | Select PROG PORT transmission speed | ||
| ON | Baud-rate 115200 | |||||
| 2 | OFF | Baud-rate 57600 | Select USER PORT transmission speed | |||
| ON | Baud-rate 115200 | |||||
| 3 | OFF | Can also be used by SERCOM and MODBUS devices | Select PROG PORT functioning mode | |||
| ON | Cannot be used by SERCOM and MODBUS devices | |||||
| 4 | OFF | ON | OFF | ON | CANbus baud-rate selector (CanOpen)1) | |
| 5 | OFF | OFF | ON | ON | ||
| Baud-rate 125KB/S | Baud-rate 250KB/S | Baud-rate 500KB/S | Baud-rate 1MB/S |
|||
| 6 | Not used | |||||
| 7 | Not used | |||||
| 8 | OFF | PROG PORT normal | Select the USER PORT as PROG PORT2) | |||
| ON | PROG PORT on USER PORT connector | |||||
1)
Valid if the declaration of the CANopen device is set the speed to 0
2)
It is possible to use the USER PORT connector as PROG PORT with RS232 electric standard, doing this the mini-USB connector of the PROG PORT is disconnected (Setting USER PORT electric standard). For this function mode also set dip 6 of SW2 to OFF.